Appendix F
Management Processor Commands
MP Command: ID
255
MP Command: ID
ID - Configure Complex Identification
• Access level—Operator
• Scope—Complex
This command configures the complex identification information. The complex identification information
includes the following:
• model number
•model string
• complex serial number
• complex system name
• original product number
• current product number
• enterprise ID and diagnostic license
This command is similar to the SSCONFIG command in ODE.
The command is protected by an authentication mechanism. The MP generates a lock word, and the user
must supply an authentication key which is dependent on the lock word. A fixed timeout of one minute
protects against this command being entered inadvertently. This command has no effect if the timeout pops or
the wrong authentication key is entered.
This command is inoperable until the MP has determined the golden complex profile.
When the machine is powered on for the first time, the CC command must be issued before the ID command
can be used.
Example F-11 ID Command
To Next Page
Loading...
