Chapter 3
Removing and Replacing Components
Removing and Replacing the Rear Electromagnetic Interference (EMI) Cover
87
Figure 3-4 Rear EMI Cover Detail
Replacing the Rear EMI Cover
The rear cover is held in place at the top by a channel in the cover that slides into a lip on the chassis.
Step 1. Push the top of the cover into the lip and rotate the cover into position flush with the chassis frame.
Step 2. Tighten the single captive screw in the lower center of the EMI cover.
Step 3. Close the rear cabinet door.
CAUTION Take care not to damage the EMI gasket on the cover.
To Next Page
Loading...
