Chapter 3
Removing and Replacing Components
Removing and Replacing the Bulk Power Supply (BPS)
91
Replacing the Bulk Power Supply
Step 1. Grip the handle with one hand while supporting the rear of the BPS in the other hand and insert
the BPS into the same slot from which it was removed.
Step 2. The BPS easily slides into the FEPS; however, use a slow firm pressure to properly seat the
connection.
Step 3. Tighten the single captive thumbscrew in the lower center of the BPS.
NOTE Do not over tighten the captive thumbscrew.
To Next Page
Loading...
