Chapter 3
Removing and Replacing Components
Removing and Replacing the Front-End Power Supply
96
Figure 3-10PDCA Locations
Step 5. Remove PDCAs using the following procedure for each.
1. Remove the L bezel.
2. Using a T15 Torx driver, loosen the four captive screws that hold the PDCA in place.
3. Pull the PDCA from the FEPS chassis and carefully set it on the tile beside the cabinet.
L Bezel
L Bezel
PDCA0
PDCA1
Rear PDCA Bezel
To Next Page
Loading...
