CLI commands
Parameters
<name> Location where the AP is installed.
snmp-server port
Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
snmp-server port <port number>
Sets the port the AP will use to respond to SNMP requests.
Parameters
<port number> SNMP port number. Range 1 - 65535.
snmp-server readonly
Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
snmp-server readonly <community>
Sets the read-only community string.
no snmp-server readonly
Deletes the read-only community string.
snmp-server readwrite
Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
snmp-server readwrite <community>
Sets the read-write community string.
no snmp-server readwrite
Deletes the read-write community string.
snmp-server trap
Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
snmp-server trap
Enables support for SNMP traps.
no snmp-server trap
Disables support for SNMP traps.
snmp-server trap community
Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
snmp-server trap community <str>
Sets the password required by the remote host that will receive the trap.
no snmp-server trap community
Deletes the password required by the remote host that will receive the trap.
2-21
To Next Page
Loading...
