CLI commands
dot1x reauth
Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
dot1x reauth
Enable this option to force 802.1X client stations to reauthenticate.
no dot1x reauth
Disables 802.1X reauthentication.
dot1x reauth period
Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
dot1x reauth period (15m | 30m | 1h | 2h | 4h | 8h | 12h)
Sets the 802.1X reauthentication interval. Client stations must reauthenticate when this interval
expires.
dot1x reauth terminate
Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
dot1x reauth terminate
Enable this option to allow client stations to remain connected during re-authentication. Client
traffic is blocked only when re-authentication fails.
no dot1x reauth terminate
Disabled this option to block client traffic during re-authentication and only activate traffic again
if authentication succeeds.
dot1x supplicant timeout
Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
802.1x supplicant time-out <seconds>
Sets the 802.1X supplicant time-out.
Parameters
<seconds> time-out in seconds.
dynamic key
Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
dynamic key
Enables dynamic key support for 802.1X and WPA.
no dynamic key
Disables dynamic key support for 802.1X and WPA.
2-38
To Next Page
Loading...
