HP MSM3xx Reference Guide

CLI commands
Virtual AP context
Path: View > Enable > Config > Virtual AP
This context provides commands for configuring Virtual AP profiles (VAP (VSC)s).
By default one profile exists with the name "". This is the default profile and cannot be deleted.
The following example shows how to add a new VAP (VSC) with egress mapped to an existing
VLAN named "hongkong":
CLI(config)# virtual ap newap
CLI(virtual-ap)# access control
CLI(virtual-ap)# egress any vlan hongkong
CLI(virtual-ap)# ssid name "newap"
CLI(virtual-ap)# ingress ssid
CLI(virtual-ap)# bandwidth high
CLI(virtual-ap)# end
CLI(config)#
virtual ap name
Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
virtual ap name <name>
Change the VAP (VSC) name.
ingress interface
Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
ingress interface (wireless | wireless) <name>
Sets the specified interface as the ingress interface traffic will be accepted on.
no ingress interface (wireless | wireless) <name>
Removes the specified interface as an ingress interface.
guest-mode
Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
guest-mode
Enables broadcast of the wireless network name (SSID).
no guest-mode
Disables broadcast of the wireless network name (SSID).
max-association
Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
max-association <stations>
Sets the maximum number of clients stations that can associate with this VAP (VSC).
<stations> Number of client stations. Range: 1 - 255.
2-54

HP MSM3xx Specifications

General

Brand	HP
Model	MSM3xx
Category	Wireless Access Point
Language	English