CLI commands
Parameters
<bytes> Maximum size (in bytes) of a PPPoE packet when transmitting. Range: 500
- 1500 bytes.
pppoe unnumbered
Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
pppoe unnumbered
Enable unnumbered mode.
no pppoe unnumbered
Disable unnumbered mode.
This feature is useful when the AP is connected to the Internet and NAT is not being used. Instead
of assigning two IP addresses to the AP, one to the Internet port and one to the LAN port, both
ports can share a single IP address. This is especially useful when a limited number of IP
addresses are available to you.
2-47
To Next Page
Loading...
