CLI commands
ssid name
Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
ssid name <name>
Specifies the WLAN name (SSID) for the profile.
vlan
Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
vlan <id>
Assigns a VLAN ID to this VAP (VSC).
no vlan
Deletes the VLAN ID for this VAP (VSC).
Parameters
<id> VLAN ID. Range: 1 - 4094.
encryption key 1
Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
encryption key <key> <value>
Sets WEP key 1.
no encryption key <key>
Deletes WEP key 1.
Parameters
<key> WEP key number. Range: 1 - 4. Keys 2 to 4 are only supported on the first
WLAN profile.
<value> Key value. The number of characters you specify for a key determines the
level of encryption the AP will provide.
For 40-bit encryption, specify 5 ASCII characters or 10 HEX digits.
For 128-bit encryption, specify 13 ASCII characters or 26 HEX digits.
encryption key format
Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
encryption key format (hex | ascii)
Specify the WEP key format.
Parameters
hex Hex keys should only include the following digits: 0-9, a-f, A-F
ascii ASCII keys are much weaker than carefully chosen hex keys. You can
include ASCII characters between 32 and 126, inclusive, in the key.
However, note that not all client stations support non-alphanumeric
characters such as spaces, punctuation, or special symbols in the key.
2-55
To Next Page
Loading...
Need help?
General
