CLI commands
Port-1 interface context
Path: View > Enable > Config > Port-1 interface
This context provides commands for configuring Port-1.
end
Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
end
Switches to parent context.
duplex
Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
duplex (auto | half | full)
Sets the duplex mode on Port-1.
Parameters
auto Lets the AP automatically set duplex mode based on the type of equipment
it is connected to.
half Forces the port to operate in half duplex mode.
full Forces the port to operate in full duplex mode.
speed
Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
speed (auto | 10 | 100)
Sets the speed of Port-1.
Parameters
auto Lets the AP automatically set port speed based on the type of equipment it
is connected to.
100 Forces the port to operate at 100 mbps.
10 Forces the port to operate at 10 mbps.
vlan
Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
vlan <id>
Sets the default VLAN ID. Range: 1 - 4094. All outgoing traffic that does not have a VLAN already
assigned to it, is sent on this VLAN.
no vlan
Deletes the default VLAN ID.
2-43
To Next Page
Loading...
Need help?
General
