CLI commands
snmp-server trap unauthorized-ap interval
Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
snmp-server trap unauthorized-ap interval <number>
If set to 0, then traps are only sent when a rogue access point is detected. If set to 0, the entire list
of rogue access points is sent each time the interval expires.
wireless-scan
Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
wireless-scan
Enables wireless neighborhood scanning.
no wireless-scan
Disables wireless neighborhood scanning.
wireless-scan period
Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
wireless-scan period <seconds>
Specifies the interval between wireless neighborhood scans.
Parameters
<seconds> Scanning interval. Range: 10 - 600 seconds.
wireless-scan url
Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
wireless-scan url <location>
Sets the URL of the file that contains a list of all authorized access points.
no wireless-scan url
Deletes the URL of the file that contains a list of all authorized access points.
The format of this file is XML. Each entry in the file is composed of two items: MAC address and
SSID. Each entry should appear on a new line.
For example:
00:00:00:07:f5:11 "AP_1"
00:00:00:07:f5:23 "AP_2"
00:00:00:07:f5:12 "AP_3"
access controller shared secret
Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
access controller shared secret <secret>
Sets the shared secret used to communicate with the service controller.
no access controller shared secret
Sets the shared secret used to communicate with the access controller.
2-35
To Next Page
Loading...
