ZPWY-MAP- Definitions
NonStop Pathway/iTS Management Programming Manual—426749-002
6-4
ZPWY-MAP-DEF-PATHWAY
TCPs, and LINKMON processes are allowed to concurrently hold links to a single
server process.
If you do not assign a value to this field, the default value is 0; any attempt by an
external TCP to access a server controlled by the PATHMON process fails.
ZMAXPROGRAMS
is the maximum number of PROGRAM descriptions that you can add to the
PATHMON configuration file.
The value must be a number from 0 through 4095. If you do not assign a value to
this field, the default is 0; this means that application programs cannot be started in
the Pathway subsystem through the START PROG or the PATHCOM RUN
PROGRAM command.
ZMAXTCPS
is the maximum number of TCP descriptions that you can add to the PATHMON
configuration file.
The value must be a number from 0 through 800.
The total of the values for ZMAXTCPS, ZMAXEXTERNALTCPS, and the TS/MP
field ZMAXLINKMONS cannot exceed 800. A maximum of 255 TCPs, external
TCPs, and LINKMON processes are allowed to concurrently hold links to a single
server process.
This field is required; there is no default.
ZMAXTELLQUEUE
is the maximum number of tell messages that can be queued for each terminal.
The value must be a number from 0 through 300. If you do not assign a value to
this field, the default is 4.
ZMAXTELLS
is the maximum number of tell messages that can exist concurrently within a
Pathway subsystem.
The value must be a number from 0 through 4095. If you do not assign a value to
this field, the default is 32.
ZMAXTERMS
is the maximum number of descriptions for dedicated and nondedicated terminals
(TERM and PROG objects) that you can add to the PATHMON configuration file
using the ADD TERM and START PROG commands.
The value must be a number from 0 through 4095. To enable PATHMON to
process the equivalent of a PATHCOM ALTER TERM or ALTER PROGRAM
command, specify a maximum of 4094 for this attribute.
To Next Page
Loading...
Need help?
General