HP NonStop Pathway/iTS

PROG Commands
NonStop Pathway/iTS Management Programming Manual—426749-002
9-4
ADD PROGTERM
ADD PROGTERM
Use the ADD PROGTERM command to add all of the attributes that define a given
device type supported by a PROG object.
Continuation
You cannot use continuation with this command to add more than one PROGTERM;
you must add each PROGTERM object separately.
Command Syntax
For tokens that may be present in the command and response buffers but are not
listed, see Unlisted Tokens on page 3-36. For descriptions of tokens and fields, see
Section 4 through Section 6.
Tokens in Response Buffer
ZSPI-TKN-RETCODE
For ADD PROGTERM, common error values for ZSPI-TKN-RETCODE are:
Command
ZPWY-CMD-ADD
Object Type
ZPWY-OBJ-PROGTERM
Tokens in Command Buffer
ZPWY-MAP-SEL-PROGTERM token-type ZPWY-DDL-SEL-PROGTERM. !r
ZPWY-MAP-DEF-PROGTERM token-type ZPWY-DDL-DEF-PROGTERM. !r
Tokens in Response Buffer
ZPWY-MAP-SEL-PROGTERM token-type ZPWY-DDL-SEL-PROGTERM.
ZSPI-TKN-RETCODE token-type ZSPI-TYP-INT.
Error
Number Error Token Description
1012 ZPWY-ERR-PM-DUPNAME The PATHMON process encountered a
duplicate PROGTERM name.
1035 ZPWY-ERR-PM-
NAMENOTDEFINED
The PROG object does not exist.