PROG Commands
NonStop Pathway/iTS Management Programming Manual—426749-002
9-5
ADD PROGTERM
For descriptions of error-token values and their associated error lists, see
Section 11, TCP Event Messages and Section 12, TCP Error Messages.
Considerations
•
An ADD PROG command must already have been issued for the PROG object
before you issue the ADD PROGTERM command.
•
Before adding a PROGTERM object to the PATHMON configuration file, you must
assign values to all of the required fields listed in this command.
•
To specify node-independence for PROGTERM object attributes, specify \* for
node names or omit node names and set ZNODEINDEPENDENT to ON in the
TS/MP START PATHWAY command.
To Next Page
Loading...
