NonStop Pathway/iTS Management Programming Manual—426749-002
11-1
11 TCP Event Messages
This section describes event messages reported by TCPs. The descriptions are given
in ascending order by event number; that is, in ascending order by the ZPWY-EVT-
values.
Message Numbers
All messages returned by the PATHMON environment are logged by the PATHMON
process; however, some messages in some number ranges represent events and
errors reported to the PATHMON process by other processes. The message number
identifies the process that reported the event, as follows:
Error messages with a value of 0 indicate that the command completed successfully
(ZPWY-VAL-OK).
Event-Message Format
Each event message in this section includes the following:
•
The number and name of the event message
•
A description of the event message cause
•
A syntax box listing:
Message Numbers in
This Range… Represent Events Reported by… With The Tokens…
1000 through 1999 PATHMON
Although some messages generated by
the PATHMON process pertain to
NonStop Pathway/iTS objects, all
messages in this range are described in
the TS/MP Management Programming
Manual.
ZPWY-EVT-PM-
ZPWY-ERR-PM-
3000 through 3999 Link managers
All messages reported by TCPs are
described in this manual.
A few of these messages can also be
reported by LINKMON processes; such
messages are described in the TS/MP
Management Programming Manual.
ZPWY-EVT-TCP-
ZPWY-ERR-TCP-
4000 through 4999 SPI (Subsystem Programmatic Interface)
These messages are described in the
TS/MP Management Programming
Manual.
ZPWY-ERR-SPI-
To Next Page
Loading...
