TERM Commands
NonStop Pathway/iTS Management Programming Manual—426749-002
8-23
START TERM
START TERM
Use the START TERM command to direct the TCP to begin executing a SCREEN
COBOL program on one or more designated TERM objects. The TCP that controls the
TERM objects must be running before you issue this command.
This command can be issued only to configured TERM objects.
Continuation
To start all TERM objects, initialize the ZTERM field in ZPWY-DDL-SEL-TERM to
ZPWY-VAL-ALLTERM. Reissue the command repeatedly, using the context token
returned by the PATHMON process, until no data is returned in the response buffer.
When you specify continuation, responses are returned only for stopped TERM
objects. For more information, see Specifying Continuation on page 3-21.
Command Syntax
For tokens that may be present in the command and response buffers but are not
listed, see Unlisted Tokens on page 3-36. For descriptions of tokens and fields, see
Section 4 through Section 6.
Command
ZPWY-CMD-START
Object Type
ZPWY-OBJ-TERM
Tokens in Command Buffer
ZSPI-TKN-CONTEXT token-type ZSPI-TYP-BYTESTRING.
ZPWY-MAP-SEL-TERM token-type ZPWY-DDL-SEL-TERM. !r
ZPWY-MAP-QUAL-TERM token-type ZPWY-DDL-QUAL-TERM.
ZPWY-MAP-PAR-START-TERM token-type ZPWY-DDL-PAR-START-TERM.
Tokens in Response Buffer
ZSPI-TKN-CONTEXT token-type ZSPI-TYP-BYTESTRING.
ZPWY-MAP-SEL-TERM token-type ZPWY-DDL-SEL-TERM.
ZSPI-TKN-RETCODE token-type ZSPI-TYP-INT.
To Next Page
Loading...
Need help?
General