HP NonStop Pathway/iTS - Zpwy-Ddl-Term-Type

ZPWY-DDL- Definitions
NonStop Pathway/iTS Management Programming Manual—426749-002
5-16
ZPWY-DDL-TERM-TYPE
ZISATTACHED directs the copy of the screen image to the attached printer. The
field has the following associations:
If you assign ZPWY-VAL-YES to ZISATTACHED for a 6520, 6530, or 6540
terminal, the SCREEN COBOL special register TERMINAL-PRINTER is ignored.
If you do not assign a value to this field, the default is ZPWY-VAL-NO.
ZPRINTERFILE
is the file name of a print device placed in the SCREEN COBOL special register
TERMINAL-PRINTER when a PROG or TERM object starts. The SCREEN
COBOL PRINT SCREEN verb obtains the printer’s file name from the TERMINAL-
PRINTER special register. You can modify the file name in the SCREEN COBOL
program’s TERMINAL-PRINTER register and then use the new file name.
You can specify either a specific node name or \*, a generic name representing the
node on which the PATHMON process is currently running. If you do not specify a
node name, the default node for file-name expansion can be affected by the value
you specify for the ZNODEINDEPENDENT field of the TS/MP START PATHWAY
command. For more information on node independence, see the Pathway/iTS
System Management Manual.
To reset this field using the TACL program, you must use the #SETBYTES built-in
function. For more information, see the SPI Programming Manual.
ZPWY-DDL-TERM-TYPE
ZPWY-DDL-TERM-TYPE specifies the device type that the TCP uses for running a
SCREEN COBOL program on a device.
The following values are valid:
T16-6530 Directs copy to a printer attached directly to the terminal.
T16-6520 Directs copy to a printer attached directly to the terminal.
IBM-3270 Directs copy to the printer, which must be attached to the
same control unit as the terminal.
def ZPWY-DDL-TERM-TYPE token-type ZSPI-DDL-OBJECT-
NAME.
IBM-3270 IBM 3270 terminal
T16-6520 6520 terminal
T16-6530 6530 terminal
CONVERSATIONAL Conversational-mode terminal