PROG Commands
NonStop Pathway/iTS Management Programming Manual—426749-002
9-6
ALTER PROG
ALTER PROG
Use the ALTER PROG command to change the attribute values of a PROG object
description that was previously added to the PATHMON configuration file.
Continuation
You cannot use continuation with this command to alter more than one PROG object
description; you must alter each PROG object description separately.
Command Syntax
For tokens that may be present in the command and response buffers but are not
listed, see Unlisted Tokens on page 3-36. For descriptions of tokens and fields, see
Section 4 through Section 6.
Considerations
•
If you have added the maximum number of PROG entries supported by the
PATHMON process (that is, 4095) and issue an ALTER PROG command, the
command fails with the following error:
*1108* TOO MANY PROGRAM ENTRIES
The command fails because the PATHMON process executes the ALTER PROG
command by creating a new PROG entry with the altered values before deleting
the existing PROG entry. When the maximum number of PROG entries already
exists, the PATHMON process does not have the space to create a new PROG.
To avoid generating this error, define and add the maximum number of PROG
entries allowed, minus 1 (that is, 4094 programs).
Command
ZPWY-CMD-ALTER
Object Type
ZPWY-OBJ-PROG
Tokens in Command Buffer
ZPWY-MAP-SEL-PROG token-type ZPWY-DDL-SEL-PROG. !r
ZPWY-MAP-DEF-PROG token-type ZPWY-DDL-DEF-PROG. !r.
Tokens in Response Buffer
ZPWY-MAP-SEL-PROG token-type ZPWY-DDL-SEL-PROG.
To Next Page
Loading...
Need help?
General