To Next Page

To Previous Page

Terminal Control Process (TCP) Commands

NonStop Pathway/iTS Management Programming Manual—426749-002

7-4

ALTER TCP

Use the ALTER TCP command to change the attribute values of a TCP that was

previously added to the PATHMON configuration file. Use the ALTER command to

alter one or more attribute values. The TCP must be stopped before you can alter an

attribute value. To alter a TCP in the running state, use the CONTROL TCP command.

This command affects only TCPs controlled by the PATHMON process in your

subsystem. It does not affect external TCPs (TCPs that are controlled by another

PATHMON process and are therefore outside this PATHMON environment).

Continuation

You cannot use continuation with this command to alter more than one TCP; you must

alter the TCPs one at a time.

Command Syntax

For tokens that might be present in the command and response buffers but are not

listed, see Unlisted Tokens on page 3-36. For descriptions of tokens and fields, see

Section 4 through Section 6.

Consideration

For ALTER commands, the values for tokens and fields omitted from the command

buffer remain unchanged.

Reset values for each field are predefined. These values are described in Section 3,

SPI Programming Considerations. To reset ZDUMPFILE, ZGUARDIANLIB,

ZGUARDIANSWAP, ZHOMETERM, ZINSPECTFILE, ZPROGRAM, ZPROCESS,

Command

ZPWY-CMD-ALTER

Object Type

ZPWY-OBJ-TCP

Tokens in Command Buffer

ZPWY-MAP-SEL-TCP token-type ZPWY-DDL-SEL-TCP. !r

ZPWY-MAP-DEF-TCP token-type ZPWY-DDL-DEF-TCP. !r

Tokens in Response Buffer

ZPWY-MAP-SEL-TCP token-type ZPWY-DDL-SEL-TCP.

HP NonStop Pathway/iTS User Manual

Questions and Answers: