TCP Error Messages
NonStop Pathway/iTS Management Programming Manual—426749-002
12-10
Error-Message Range 3000 Through 3999
Effect. The program terminates abnormally.
Recovery. Contact your service provider.
3025: ZPWY-ERR-TCP-TERMDATAFORMAT
The input data received from the terminal did not have the correct structure, even after
screen recovery and retries.
This error does not appear in the RETCODE token or in an error list; it appears only in
response to a STATUS TCP or STATUS TERM command.
Effect. The I/O operation fails.
Recovery. Run diagnostics for the device. If a front-end process is being used, check
that it is correctly coded to emulate the type of the device that was specified.
3027: ZPWY-ERR-TCP-TMFVIOLATION
The requested operation did not match the TMF transaction mode state.
This error does not appear in the RETCODE token or in an error list; it appears only in
response to a STATUS TCP or STATUS TERM command.
Effect. The operation fails.
Recovery. Isolate and correct the problem within the SCREEN COBOL program. For
instructions on how to locate the problem within the program, see Additional
Information for Terminal Errors on page 12-3.
3028: ZPWY-ERR-TCP-TMFFATAL
A fatal error occurred during a call to a TMF subsystem command.
This error does not appear in the RETCODE token or in an error list; it appears only in
response to a STATUS TCP or STATUS TERM command.
Effect. The call to the TMF procedure fails.
Recovery. For information regarding the specified file-system error, see the Guardian
Procedure Errors and Messages Manual.
3029: ZPWY-ERR-TCP-TMFMAXRESTARTS
The TCP attempted to restart a transaction the number of times defined for the
ZMAXTMFRESTARTS field in ZPWY-DDL-DEF-PATHWAY.
This error does not appear in the RETCODE token or in an error list; it appears only in
response to a STATUS TCP or STATUS TERM command.
Effect. The transaction is not restarted.
To Next Page
Loading...
Need help?
General