TCP Error Messages
NonStop Pathway/iTS Management Programming Manual—426749-002
12-47
Error-Message Range 3000 Through 3999
Effect. The TCP terminates. This message may or may not be reported to the
PATHMON process and written to the LOG1, but this message is written to the $0
collector process.
Recovery. Contact your service provider.
3217: ZPWY-ERR-TCP-TRAPPED
A trap occurred in the TCP because of a hardware or software failure. This is a TCP
internal error.
This error does not appear in the RETCODE token or in an error list; it appears only in
response to a STATUS TCP or STATUS TERM command.
Effect. The TCP terminates. This message may or may not be reported to the
PATHMON process and logged. The message, with the addition of the trap number, is
written to the $0 collector process.
Recovery. Contact your service provider.
3218: ZPWY-ERR-TCP-BUTAKEOVER
The backup process took over processing from the primary process.
This error does not appear in the RETCODE token or in an error list; it appears only in
response to a STATUS TCP or STATUS TERM command.
Effect. None.
Recovery. Informational message only; no corrective action is needed.
3219: ZPWY-ERR-TCP-DUMPTAKEN
A TCP memory dump completed.
This error does not appear in the RETCODE token or in an error list; it appears only in
response to a STATUS TCP or STATUS TERM command.
Effect. None.
Recovery. Informational message only; no corrective action is needed.
3220: ZPWY-ERR-TCP-INSPECTNOTENABLED
The TERM object is configured with the ZINSPECT field set to ZPWY-VAL-ON, but the
TCP is configured with the ZINSPECT field set to ZPWY-VAL-OFF.
To Next Page
Loading...
Need help?
General