NonStop Pathway/iTS Management Programming Manual—426749-002
12-1
12 TCP Error Messages
This section describes the error messages reported by link managers. The descriptions
are given in ascending order by error number; that is, in ascending order by the
ZPWY-ERR- values.
Message Numbers
All messages returned by the PATHMON environment are logged by the PATHMON
process; however, some messages in some number ranges represent events and
errors reported to the PATHMON process by other processes. The message number
identifies the process that reported the error, as follows:
Error messages with a value of 0 indicate that the command completed successfully
(ZPWY-VAL-OK).
Error Presentation
Most Pathway subsystem errors reported to a management application are returned in
the response buffer the application receives from the PATHMON process. Pathway
subsystem errors reported to SPI requesters are returned in one of the following:
•
In the response buffer for a STATUS TCP or STATUS TERM command (as a
number in the ZERROR field of ZPWY-DDL-STATUS-TCP or
ZPWY-DDL-STATUS-TERMDETAIL)
Message Numbers in
This Range… Represent Errors Reported by… With The Tokens…
1000 through 1999 PATHMON
Although some messages generated by
the PATHMON process pertain to
NonStop Pathway/iTS objects, all
messages in this range are described in
the TS/MP Management Programming
Manual.
ZPWY-EVT-PM-
ZPWY-ERR-PM-
3000 through 3999 Link managers
All messages reported by TCPs are
described in this manual.
A few of these messages can also be
reported by LINKMON processes; such
messages are described in the TS/MP
Management Programming Manual.
ZPWY-EVT-TCP-
ZPWY-ERR-TCP-
4000 through 4999 SPI (Subsystem Programmatic Interface)
These messages are described in the
TS/MP Management Programming
Manual.
ZPWY-ERR-SPI-
To Next Page
Loading...
