HP NonStop Pathway/iTS - Terminal Control Process (TCP) Commands

NonStop Pathway/iTS Management Programming Manual—426749-002
7-1
7
Terminal Control Process (TCP)
Commands
This section provides complete descriptions for the commands that enable you to
define and control TCPs within a Pathway subsystem (that is, TCPs controlled by the
same PATHMON process):
With these commands, you can do the following:
•
Define and modify TCP attributes.
•
Add and delete TCPs.
•
Start and stop TCPs.
•
Return TCP attribute and status information.
•
Control TCP operation.
For a brief description of each object type listed above, see Object Types on page 3-6.
The TCP version used is identified by the program name
$SYSTEM.SYSTEM.PATHTCP2. PATHTCP2 uses extended data segments for logical
memory.
Commands Object Types
ZPWY-CMD-ADD ZPWY-OBJ-TCP
ZPWY-CMD-ALTER ZPWY-OBJ-TCP
ZPWY-CMD-CONTROL ZPWY-OBJ-TCP
ZPWY-CMD-DELETE ZPWY-OBJ-TCP
ZPWY-CMD-GETVERSION ZPWY-OBJ-TCP
ZPWY-CMD-INFO ZPWY-OBJ-TCP
ZPWY-CMD-REFRESHCODE ZPWY-OBJ-TCP
ZPWY-CMD-START ZPWY-OBJ-TCP
ZPWY-CMD-STATS ZPWY-OBJ-SCTCP
ZPWY-OBJ-TCP
ZPWY-OBJ-TCPSC
ZPWY-CMD-STATUS ZPWY-OBJ-TCP
ZPWY-OBJ-TCPLINK
ZPWY-CMD-STOP ZPWY-OBJ-TCP
ZPWY-CMD-SWITCH ZPWY-OBJ-TCP