HP NonStop Pathway/iTS - PROG Commands; Add Prog

NonStop Pathway/iTS Management Programming Manual—426749-002
9-1
9 PROG Commands
This section provides complete descriptions of the commands that enable you to define
and control PROG objects; the commands are listed in alphabetical order:
These commands define and control templates used by the PATHMON process when
creating temporary TERM objects in response to a START PROG command. The
templates define tasks that enable TCPs to run screen programs temporarily on one or
more devices. With these commands you can do the following:
•
Define and modify PROG object attributes.
•
Add and delete PROG object templates.
•
Start the initial screen program defined in the PROG template and add and start a
temporary TERM object.
•
Return PROG object attributes.
For a brief description of each object type, see Object Types on page 3-6.
ADD PROG
Use the ADD PROG command to enter the name and the description of a PROG
object into the PATHMON configuration file.
Continuation
You cannot use continuation to add more than one PROG object description; you must
add each PROG description separately.
Commands Object Types
ZPWY-CMD-ADD ZPWY-OBJ-PROG
ZPWY-OBJ-PROGTERM
ZPWY-CMD-ALTER ZPWY-OBJ-PROG
ZPWY-OBJ-PROGTERM
ZPWY-CMD-DELETE ZPWY-OBJ-PROG
ZPWY-OBJ-PROGTERM
ZPWY-CMD-INFO ZPWY-OBJ-PROG
ZPWY-OBJ-PROGTERM
ZPWY-CMD-START ZPWY-OBJ-PROG