HP NonStop Pathway/iTS

PROG Commands
NonStop Pathway/iTS Management Programming Manual—426749-002
9-2
ADD PROG
Command Syntax
For tokens that may be present in the command and response buffers but are not
listed, see Unlisted Tokens on page 3-36. For descriptions of tokens and fields, see
Section 4 through Section 6.
Tokens in Response Buffer
ZSPI-TKN-RETCODE
For ADD PROG, common error values for ZSPI-TKN-RETCODE are:
For descriptions of error-token values and their associated error lists, see
Section 11, TCP Event Messages and Section 12, TCP Error Messages.
Considerations
•
Before adding a PROG object description to the PATHMON configuration file, you
must assign values to all of the required fields listed in this command.
•
Each PROG name (the value in ZPWY-DDL-SEL-PROG) must be unique in the
Pathway subsystem.
Command
ZPWY-CMD-ADD
Object Type
ZPWY-OBJ-PROG
Tokens in Command Buffer
ZPWY-MAP-SEL-PROG token-type ZPWY-DDL-SEL-PROG. !r
ZPWY-MAP-DEF-PROG token-type ZPWY-DDL-DEF-PROG. !r
Tokens in Response Buffer
ZPWY-MAP-SEL-PROG token-type ZPWY-DDL-SEL-PROG.
ZSPI-TKN-RETCODE token-type ZSPI-TYP-INT.
Error
Number Error Token Description
1012 ZPWY-ERR-PM-DUPNAME The PATHMON process encountered a
duplicate PROG object name.
1108 ZPWY-ERR-PM-
TOOMANYPROG
The value specified for ZMAXPROGS
was reached.