To Next Page

To Previous Page

Terminal Control Process (TCP) Commands

NonStop Pathway/iTS Management Programming Manual—426749-002

7-15

START TCP

Use the START TCP command to initiate operation of a TCP. This command cannot

initiate an external TCP (a TCP that is controlled by another PATHMON process and is

therefore outside this PATHMON environment). If the primary processor defined for a

TCP is unavailable, the PATHMON process starts the TCP in the backup processor

defined for that TCP.

Continuation

To start all TCPs, initialize the ZTCP field in ZPWY-DDL-SEL-TCP to

ZPWY-VAL-ALLTCP. Reissue the command repeatedly, using the context token

returned by the PATHMON process, until no data is returned in the reply buffer.

When you specify continuation, responses are returned only for TCPs in the stopped

state. For more information, see Specifying Continuation on page 3-21.

Command Syntax

For tokens that may be present in the command and response buffers but are not

listed, see Unlisted Tokens on page 3-36. For descriptions of tokens and fields, see

Section 4 through Section 6.

Command

ZPWY-CMD-START

Object Type

ZPWY-OBJ-TCP

Tokens in Command Buffer

ZSPI-TKN-CONTEXT token-type ZSPI-TYP-BYTESTRING.

ZPWY-MAP-SEL-TCP token-type ZPWY-DDL-SEL-TCP. !r

ZPWY-MAP-QUAL-TCP token-type ZPWY-DDL-QUAL-TCP.

Tokens in Response Buffer

ZSPI-TKN-CONTEXT token-type ZSPI-TYP-BYTESTRING.

ZPWY-MAP-SEL-TCP token-type ZPWY-DDL-SEL-TCP.

ZSPI-TKN-RETCODE token-type ZSPI-TYP-INT.

HP NonStop Pathway/iTS User Manual

Questions and Answers: