HP NonStop Pathway/iTS

TCP Error Messages
NonStop Pathway/iTS Management Programming Manual—426749-002
12-27
Error-Message Range 3000 Through 3999
3118: ZPWY-ERR-TCP-BADSCSTATE
The state of the specified server does not allow the requested operation to take place.
This is a Pathway internal error. This event can be triggered by either the TCP or the
TS/MP LINKMON process.
For a description of tokens that are present in this event message but are not listed or
described here, see “Event Management,” in Section 6 of the TS/MP Management
Programming Manual.
Token Description
ZSPI-TKN-ERROR
contains ZPWY-ERR-TCP-BADSCSTATE.
Effect. The operation fails.
Recovery. Contact your service provider.
3119: ZPWY-ERR-TCP-MAXSCPROCESS
The value configured for the ZMAXSERVERPROCESSES field in ZPWY-DDL-DEF-
TCP was exceeded.
This error does not appear in the RETCODE token or in an error list; it appears only in
response to a STATUS TCP or STATUS TERM command.
Effect. The operation fails.
Recovery. Increase the value of the ZMAXSERVERPROCESSES field and repeat the
operation.
3121: ZPWY-ERR-TCP-DIRIO
A file-system error occurred during an I/O operation to the TCLPROG directory file.
This error does not appear in the RETCODE token or in an error list; it appears only in
response to a STATUS TCP or STATUS TERM command.
Effect. The I/O operation fails.
ZSPI-TKN-ERRLIST token-type ZSPI-TYP-LIST.
ZSPI-TKN-ERROR token-type ZSPI-TYP-ERROR.
ZPWY-TKN-REQCOMMAND token-type ZSPI-TYP-INT.
ZPWY-TKN-REQOBJECTTYPE token-type ZSPI-TYP-UINT.
ZPWY-TKN-REQ***NAME token-type ZPWY-TYP-***NAME
ZPWY-TKN-ERRCOMMAND token-type ZSPI-TYP-INT.
ZPWY-TKN-ERROBJECTTYPE token-type ZSPI-TYP-UINT.
ZPWY-TKN-***NAME token-type ZSPI-TYP-***NAME.
ZSPI-TKN-ENDLIST token-type ZSPI-TYP-SSCTL.