EasyManuals Logo

HP NonStop Pathway/iTS User Manual

HP NonStop Pathway/iTS
694 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #585 background imageLoading...
Page #585 background image
TCP Error Messages
NonStop Pathway/iTS Management Programming Manual—426749-002
12-15
Error-Message Range 3000 Through 3999
This error does not appear in the RETCODE token or in an error list; it appears only in
response to a STATUS TCP or STATUS TERM command.
Effect. The operation fails.
Recovery. Use the ALTER TERM command to specify a valid value for the
ZIOPROTOCOL field. The ZINFO field of the STATUS TERM display shows the reply
value received by the TCP from the PATHMON process.
3056: ZPWY-ERR-TCP-CACHEFATAL
A 6540 device encountered a fatal error while running in caching mode. This situation
could be caused by memory parity errors, disk errors, or diskette errors.
This error does not appear in the RETCODE token or in an error list; it appears only in
response to a STATUS TCP or STATUS TERM command.
Effect. The terminal is suspended.
Recovery. Issue a RESUME TERM command to correct the situation; however, this
will only succeed if the 6540 device error was transient. If the error is not transient, run
terminal diagnostics.
If the issuing of a RESUME TERM command does not correct the situation and
terminal diagnostics do not reveal any problem, contact your service provider.
3057: ZPWY-ERR-TCP-CACHEMODECHANGE
A 6540 terminal performing screen caching had an error that forced it to 6530 device
emulation.
This error does not appear in the RETCODE token or in an error list; it appears only in
response to a STATUS TCP or STATUS TERM command.
Effect. The caching function has been disabled and the device is emulating a 6530
terminal.
Recovery. Check the 6540 terminal for disk errors and other problems.
3058: ZPWY-ERR-TCP-BADPCODEVERSION
The SCREEN COBOL pseudocode for the program unit is not compatible with this
version of the TCP.
This error does not appear in the RETCODE token or in an error list; it appears only in
response to a STATUS TCP or STATUS TERM command.
Effect. The program terminates abnormally.
Recovery. Upgrade the TCP you are using to the same revision level as the
SCOBOLX compiler with which the program unit was compiled.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP NonStop Pathway/iTS and is the answer not in the manual?

HP NonStop Pathway/iTS Specifications

General IconGeneral
BrandHP
ModelNonStop Pathway/iTS
CategorySoftware
LanguageEnglish

Related product manuals