HP NonStop Pathway/iTS User Manual

Tell Message Commands
NonStop Pathway/iTS Management Programming Manual—426749-002
10-3
DELETE TELL
DELETE TELL
Use the DELETE TELL command to delete a pending tell message.
Continuation
You cannot use continuation with this command to delete all tell messages; you must
explicitly delete each tell message by number.
Command Syntax
For tokens that might be present in the command and response buffers but are not
listed, see Unlisted Tokens on page 3-36. For descriptions of tokens and fields, see
Section 4 through Section 6.
Command
ZPWY-CMD-DELETE
Object Type
ZPWY-OBJ-TELL
Tokens in Command Buffer
ZPWY-MAP-SEL-TELL token-type ZPWY-DDL-SEL-TELL. !r
Tokens in Response Buffer
ZPWY-MAP-SEL-TELL token-type ZPWY-DDL-SEL-TELL.

HP NonStop Pathway/iTS Specifications

General

Brand	HP
Model	NonStop Pathway/iTS
Category	Software
Language	English