HP NonStop Pathway/iTS

TCP Error Messages
NonStop Pathway/iTS Management Programming Manual—426749-002
12-49
Error-Message Range 3000 Through 3999
For a description of tokens that are present in this event message but are not listed or
described here, see “Event Management,” in Section 6 of the TS/MP Management
Programming Manual.
Token Descriptions
ZSPI-TKN-ERROR
contains ZPWY-ERR-TCP-INSPECTMAXTERM.
ZPWY-TKN-REQCOMMAND
contains ZPWY-CMD-INSPECT.
ZPWY-TKN-REQOBJECTTYPE
contains ZPWY-OBJ-TERM.
ZPWY-TKN-REQTERMNAME
contains the name of the TERM object for which the Inspect command was issued.
Effect. The Inspect operation fails.
Recovery. Reduce the number of terminals under the control of a TCP that are
attempting to use the Inspect process.
3222: ZPWY-ERR-TCP-INSPECTMAXBKPT
An attempt was made to set more than 20 program breakpoints for each TCP.
This error does not appear in the RETCODE token or in an error list; it appears only in
response to a STATUS TCP or STATUS TERM command.
Effect. The Inspect operation fails.
Recovery. Set fewer than 20 program breakpoints for each TCP.
3223: ZPWY-ERR-TCP-INSPECTATBKPT
An Inspect command was issued to a TERM object already at a program breakpoint.
ZSPI-TKN-ERRLIST token-type ZSPI-TYP-LIST.
ZSPI-TKN-ERROR token-type ZSPI-TYP-ERROR.
ZPWY-TKN-REQCOMMAND token-type ZSPI-TYP-INT.
ZPWY-TKN-REQOBJECTTYPE token-type ZSPI-TYP-UINT.
ZPWY-TKN-REQTERMNAME token-type ZPWY-TYP-TERMNAME
ZPWY-TKN-ERRCOMMAND token-type ZSPI-TYP-INT.
ZPWY-TKN-ERROBJECTTYPE token-type ZSPI-TYP-UINT.
ZPWY-TKN-TERMNAME token-type ZSPI-TYP-TERMNAME.
ZSPI-TKN-ENDLIST token-type ZSPI-TYP-SSCTL.