HP NonStop Pathway/iTS

TCP Error Messages
NonStop Pathway/iTS Management Programming Manual—426749-002
12-3
Additional Information for Terminal Errors
Additional Information for Terminal Errors
Some messages pertaining to terminal errors include additional error-message text on
the reason for the terminal error. The additional information, which is placed at the end
of the error-message text and always starts with three hyphens ( --- ), is formatted as
follows:
--- INST CODE inst-code AT OFFSET %offset IN PROGRAM UNIT
program-unit (version) IN TCLPROG tclprog
inst-code is the program unit instruction code; offset is the address of the
instruction code within the program unit; program-unit is the program unit name;
version is the program unit version; and tclprog is the name of the file where the
program unit is located.
For example:
*1048* TERM TERM-1, SUSPENDED: *3117* SERVER CLASS UNDEFINED ---
INST CODE: SEND AT OFFSET %37 IN PROGRAM UNIT PROG-X(1) IN
TCLPROG \SYS.$VOL.SUBVOL.POBJ
Error Recovery
When an error originates in the SCREEN COBOL program, use the additional error-
message text to obtain the name, version, and instruction address of the program unit
being executed. You can isolate the problem to a paragraph in the source program
using the information obtained from the additional error-message text and the compiler
listing with a MAP.
Error-Message Range 3000 Through 3999
Error messages numbered from 3000 through 3999 describe events reported by TCPs.
3001: ZPWY-ERR-TCP-BADCODE
A SCREEN COBOL object file is corrupted, or the SCREEN COBOL compiler
generated invalid code. This is a TCP internal error.
This error does not appear in the RETCODE token or in an error list; it appears only in
response to a STATUS TCP or STATUS TERM command.
Effect. The terminal is suspended.
Recovery. Contact your service provider.
3002: ZPWY-ERR-TCP-DEPENDVARTOOBIG
The value of a DEPENDING ON data item was larger than the limit specified in the
OCCURS clause.