TCP Error Messages
NonStop Pathway/iTS Management Programming Manual—426749-002
12-28
Error-Message Range 3000 Through 3999
Recovery. For information regarding the specified file-system error, see the Guardian
Procedure Errors and Messages Manual.
3122: ZPWY-ERR-TCP-CODIO
A file-system error occurred during an I/O operation to the TCLPROG code file.
This error does not appear in the RETCODE token or in an error list; it appears only in
response to a STATUS TCP or STATUS TERM command.
Effect. The I/O operation fails.
Recovery. For information regarding the specified file-system error, see the Guardian
Procedure Errors and Messages Manual.
3123: ZPWY-ERR-TCP-NOSCPROCESS
The TCP could not link to a server. The SCREEN COBOL run unit was waiting for a
link to a server class when the server class became unavailable.
This error does not appear in the RETCODE token or in an error list; it appears only in
response to a STATUS TCP or STATUS TERM command.
Effect. The SEND operation fails.
Recovery. Recovery depends on why the SEND failed, which is indicated in an earlier
message. For additional information, see the description of the earlier message.
Recovery. 3124: ZPWY-ERR-TCP-EXITWITHERROR
A SCREEN COBOL program executed an EXIT PROGRAM WITH ERROR verb with
no higher-level CALL ON ERROR verb present to handle the exit. The value of the
TERMINATION-STATUS special register is shown in the INFO field of the STATUS
TERM display.
This error does not appear in the RETCODE token or in an error list; it appears only in
response to a STATUS TCP or STATUS TERM command.
Effect. The program terminates.
Recovery. Isolate and correct the problem within the SCREEN COBOL program. For
instructions on how to locate the problem within the program, see Additional
Information for Terminal Errors on page 12-3.
3125: ZPWY-ERR-TCP-UNSOLREJECTEDSTOP
The TCP rejected unsolicited messages that were queued for a terminal when the
terminal was stopped, suspended, or aborted, either programmatically or by operator
command.
This error does not appear in the RETCODE token or in an error list; it appears only in
response to a STATUS TCP or STATUS TERM command.
To Next Page
Loading...
Need help?
General