ZPWY-MAP- Definitions
NonStop Pathway/iTS Management Programming Manual—426749-002
6-27
ZPWY-MAP-DEF-TERM
ZAUTORESTART can have the following values:
If you do not assign a value to this field, the default is 0.
ZBREAK
specifies whether the TCP accepts the Break key function for its devices running in
conversational mode. ZBREAK can have the following values:
If the TCP is executing a SCREEN COBOL program in conversational mode, the
user can press the Break key to terminate ACCEPT and DISPLAY statements
prematurely.
If the user presses the Break key while the TCP is executing a DISPLAY
statement, the device output stops and the DISPLAY statement is terminated
normally with the special register TERMINATION-SUBSTATUS set to 1. If the user
does not press the Break key, TERMINATION-SUBSTATUS is set to 0 after the
completion of a DISPLAY statement.
If the user presses the Break key while the TCP is executing an ACCEPT
statement coded with an ESCAPE ON ABORT clause, the TCP stops accepting
input and terminates the ACCEPT statement without changes to the Working-
Storage Section. Pressing the Break key has no effect on the TCP when the
ACCEPT statement is coded without an ESCAPE ON ABORT clause.
If the TCP is executing a statement other than ACCEPT or DISPLAY, its operation
is not affected when the user presses the Break key.
If you do not assign a value to this field, the default is ZPWY-VAL-OFF. This field’s
value is effective only for devices running in conversational mode. If a process is
running as a terminal emulator, the value for this field always defaults to ZPWY-
VAL-OFF.
0 Specifies no automatic restarts.
1 through 32,767 Directs the PATHMON process to allow this many
automatic restarts in 10 minutes.
-1 Directs the PATHMON process to allow unlimited
automatic restarts.
ZPWY-VAL-OFF The TCP does not accept the Break key.
ZPWY-VAL-ON The TCP accepts the Break key.
To Next Page
Loading...
Need help?
General