ZPWY-MAP- Definitions
NonStop Pathway/iTS Management Programming Manual—426749-002
6-32
ZPWY-MAP-DEF-TERM
ZTMF
specifies whether the TMF subsystem runs with this program. For more information
about this parameter, see the Pathway/iTS System Management Manual. The
following values are valid:
If you do not assign a value to this field, the default is ZPWY-VAL-ON.
ZTERMTYPEINFO
specifies the type of device on which the terminal runs. If you assigned a process
file name to the ZFILE field, you must also assign a value to ZTERMTYPE,
because ZTERMTYPE specifies the type of device that the process is emulating.
The fields are described under ZPWY-DDL-TERMTYPE-INFO in this section.
ZTRAILINGBLANKS
specifies whether the TCP should suppress the display of trailing ASCII blank
characters in output lines sent to terminals by the SCREEN COBOL DISPLAY and
SEND MESSAGE verbs. ZTRAILINGBLANKS has the following values:
This field affects terminals defined as TYPE CONVERSATIONAL and affects
programs defined as TYPE INTELLIGENT that use delimited format messages.
This parameter has no effect on VARYING1 and VARYING2 message formats.
If you do not assign a value to this field, the default is ZPWY-VAL-ON.
ZPWY-VAL-ON Invokes TMF auditing when necessary. The ABORT-
TRANSACTION, BEGIN-TRANSACTION, END-
TRANSACTION, and RESTART-TRANSACTION verbs
perform the functions described in the Pathway SCREEN
COBOL Reference Manual.
ZPWY-VAL-OFF Prevents TMF auditing. The TRANSACTION-ID special
register is set to SPACES after the BEGIN-TRANSACTION
verb executes.
ZPWY-VAL-OFF Directs the TCP to suppress trailing ASCII blanks.
ZPWY-VAL-ON Directs the TCP not to suppress trailing ASCII blanks.
To Next Page
Loading...
Need help?
General