To Next Page

To Previous Page

TCP Event Messages

NonStop Pathway/iTS Management Programming Manual—426749-002

11-288

ZEMS-TKN-SUBJECT-MARK

indicates either ZPWY-TKN-TERMNAME or ZPWY-TKN-TCPNAME, which

contains the name of the TERM or TCP that is the subject of this event message.

If the subject token is ZPWY-TKN-TERMNAME, then

ZPWY-TKN-INSTRUCTION, ZPWY-TKN-PUNAME, ZPWY-TKN-PUOFFSET,

ZPWY-TKN-PUVERSION, and ZPWY-TKN-TCLPROGFNAME are included;

otherwise, these tokens are omitted.

ZPWY-TKN-EVENTCLASS

has the value ZPWY-VAL-ERROREVENT.

ZPWY-TKN-UNSOLREJECTEDERROR

contains an error number indicating why an unsolicited message was rejected. N

indicates that this token can occur in a nested message.

ZPWY-TKN-INSTRUCTION, ZPWY-TKN-PUNAME, ZPWY-TKN-PUOFFSET,

ZPWY-TKN-PUVERSION, and ZPWY-TKN-TCLPROGFNAME

are conditional tokens specific to this event message; these tokens are included

only if the subject token is ZPWY-TKN-TERMNAME. For descriptions of these

tokens, see the TS/MP Management Programming Manual.

Effect. The TCP rejects the unsolicited message and replies to the sender without

delivering it to the target requester.

Recovery. Recovery depends on the type of the error that occurred. errnum can be

one of the following:

0 No error.

1 A file-system error occurred.

2 Target terminal is suspended.

3 Target terminal queue is full. (The TERM MAXINPUTMSGS configuration value

has been exceeded.)

4 Target TCP queue area is full.

5 Target queueing is not enabled. (The TCP MAXINPUTMSGS configuration

value is set to 0.)

6 Length field in the message exceeds the configured maximum for the TCP.

7 There was an unrecognizable request code (refers to MSG-ID and MSG-

VERSION fields).

8 Named terminal is not found.

HP NonStop Pathway/iTS User Manual

Questions and Answers: