HP ProCurve 2610 - Page 335

ProCurve Stack Management
Configuring Stack Management
Figure 8-20. Example of a Member’s Stacking Status Screen
Viewing Candidate Status. This procedure displays the Candidate’s
stacking configuration.
To display the status for a Candidate:
1. Use Telnet (if the Candidate has a valid IP address for your network) or
a direct serial port connection to access the menu interface Main Menu
for the Candidate switch and select
9. Stacking ...
1. Stacking Status (This Switch)
You will then see the Candidate’s Stacking Status screen:
Figure 8-21. Example of a Candidate’s Stacking Screen
8-29