HP ProCurve 2610 User Manual

ProCurve Stack Management
Configuring Stack Management
The stack commander command
configures the Commander and names
the stack.
The Commander appears in the stack as Switch
Number (SN) 0.
Figure 8-26. Example of the Commander’s Show Stack Screen with Only the Commander
Discovered
Using a Member’s CLI to Convert the Member to the Commander of a
New Stack. This procedure requires that you first remove the Member from
its current stack, then create the new stack. If you do not know the MAC
address for the Commander of the current stack, use show stack to list it.
Syntax: no stack
stack commander < stack name >
Suppose, for example, that a ProCurve switch named “Bering Sea” is a Member
of a stack named “Big_Waters”. To use the switch’s CLI to convert it from a
stack Member to the Commander of a new stack named “Lakes”, you would
use the following commands:
8-35

HP ProCurve 2610 Specifications

General

Switching Capacity	12.8 Gbps
Forwarding Rate	9.5 Mpps
MAC Address Table Size	8000 entries
Layer	Layer 2
RAM	64 MB
Flash Memory	16 MB
Jumbo Frame Support	Yes
Manageable	Yes
Operating Humidity	15% to 95% non-condensing
Ports	24 x 10/100
VLANs	256
Management	Web, CLI, SNMP
Power Supply	Internal
Operating Temperature	0°C to 40°C
Dimensions (W x D x H)	17.42 x 12.73 x 1.73 in