5-9
Multiple Instance Spanning-Tree Operation
802.1s Multiple Spanning Tree Protocol (MSTP)
Caution When you enable MSTP on the switch, the default MSTP spanning tree
configuration settings comply with the values recommended in the IEEE
802.1s Multiple Spanning Tree Protocol (MSTP) standard. Note that inappro-
priate changes to these settings can result in severely degraded network
performance. For this reason, ProCurve strongly recommends that changing
these default settings be reserved only for experienced network administra-
tors who have a strong understanding of the IEEE 802.1D/w/s standards
and operation.
How MSTP Operates
In the factory default configuration, spanning tree operation is off. Also, the
switch retains its currently configured spanning tree parameter settings when
disabled. Thus, if you disable spanning tree, then later re-enable it, the param-
eter settings will be the same as before spanning tree was disabled. The switch
also includes a “Pending” feature that enables you to exchange MSTP config-
urations with a single command. (Refer to “Enabling an Entire MST Region at
Once or Exchanging One Region Configuration for Another” on page 5-38.)
Note The switch automatically senses port identity and type, and automatically
defines spanning-tree parameters for each type, as well as parameters that
apply across the switch. Although these parameters can be adjusted, ProCurve
strongly recommends leaving these settings in their default configurations
unless the proposed changes have been supplied by an experienced network
administrator who has a strong understanding of the IEEE 802.1D/w/s
standards and operation.
MST Regions
All MSTP switches in a given region must be configured with the same VLANs.
Also, each MSTP switch within the same region must have the same VLAN-to-
instance assignments. (A VLAN can belong to only one instance within any
region.) Within a region:
■ All of the VLANs belonging to a given instance compose a single, active
spanning-tree topology for that instance.
■ Each instance operates independently of other regions.
Between regions there is a single, active spanning-tree topology.
To Next Page
Loading...
Need help?
General
