HP ProCurve Series 2810 User Manual

6-18
Quality of Service (QoS): Managing Bandwidth More Effectively
Using QoS Types To Configure QoS for Outbound Traffic
Using QoS Types To Configure QoS for
Outbound Traffic
Note In addition to the information in this section on the various QoS types, refer
to “QoS Operating Notes and Restrictions” on page 6-66.
Viewing the QoS Configuration
Examples of the show qos output are included with the example for each
priority type.
QoS Feature Default Menu CLI Web
UDP/TCP Priority Disabled — page 6-20 Refer to Online Help.
IP-Device Priority Disabled — page 6-27 “
IP Type-of-Service Priority Disabled — page 6-33 “
VLAN-ID Priority Disabled — page 6-46 “
Interface (Source-Port)
Priority
Disabled — page 6-52 “
Syntax: show qos < priority-type >
tcp-udp-port-priority
Displays the current TCP/UDP port priority
configuration. Refer to figure 6-8 on page 6-26.
device-priority
Displays the current device (IP address) priority
configuration. Refer to figure 6-9 on page 6-29.
type-of-service
Displays the current type-of-service priority
configuration. The display output differs according to
the ToS option used:
■ IP Precedence: Refer to figure 6-13 on page 6-34.
■ Diffserve: Refer to figure 6-15 on page 6-38.

HP ProCurve Series 2810 Specifications

General

Layer	Layer 2
Form Factor	Rack-mountable
Power Supply	Internal
Jumbo Frame Support	Yes
Uplink Ports	4 x dual-personality ports (10/100/1000 or mini-GBIC)
Switching Capacity	48 Gbps
Throughput	35.7 Mpps
Forwarding Rate	35.7 million pps
Management	Web, SNMP, CLI
MAC Address Table Size	16000 entries
Routing Protocol	Static routing
Features	VLAN support, QoS, IGMP snooping
Operating Temperature	32°F to 113°F (0°C to 45°C)
Operating Humidity	15% to 95% non-condensing
Model	HP ProCurve Series 2810
Ports	24 x 10/100/1000 (Gigabit)