HP ProCurve Series 2810 User Manual

7-18
ProCurve Stack Management
Configuring Stack Management
• To change Auto Join or Transmission Interval, use [Tab] to select the
desired parameter, and:
– To change Auto Join, use the Space bar.
– To change Transmission Interval, type in the new value in the
range of 1 to 300 seconds.
Note: All switches in the stack must be set to the same transmis-
sion interval to help ensure proper stacking operation. ProCurve
recommends that you leave this parameter set to the default 60
seconds.
Then go to step 5.
5. Press [Enter] to return the cursor to the Actions line.
6. Press
[S] (for Save) to save your configuration changes and return to the
Stacking menu.
Using the Commander To Manage The Stack
The Commander normally operates as your stack manager and point of entry
into other switches in the stack. This typically includes:
■ Adding new stack members
■ Moving members between stacks
■ Removing members from a stack
■ Accessing stack members for individual configuration changes and traffic
monitoring
The Commander also imposes its passwords on all stack members and pro-
vides SNMP community membership to the stack. (See “SNMP Community
Operation in a Stack” on page 7-45.)

HP ProCurve Series 2810 Specifications

General

Layer	Layer 2
Form Factor	Rack-mountable
Power Supply	Internal
Jumbo Frame Support	Yes
Uplink Ports	4 x dual-personality ports (10/100/1000 or mini-GBIC)
Switching Capacity	48 Gbps
Throughput	35.7 Mpps
Forwarding Rate	35.7 million pps
Management	Web, SNMP, CLI
MAC Address Table Size	16000 entries
Routing Protocol	Static routing
Features	VLAN support, QoS, IGMP snooping
Operating Temperature	32°F to 113°F (0°C to 45°C)
Operating Humidity	15% to 95% non-condensing
Model	HP ProCurve Series 2810
Ports	24 x 10/100/1000 (Gigabit)