HP ProCurve Series 2810 User Manual

6-29
Quality of Service (QoS): Managing Bandwidth More Effectively
Using QoS Types To Configure QoS for Outbound Traffic
Figure 6-9. Example of Configuring and Listing 802.1p Priority Assignments for
Packets Carrying Specific IP Addresses
Assigning a DSCP Policy Based on IP Address
This option assigns a previously configured DSCP policy (codepoint and
802.1p priority) to outbound IP packets having the specified IP address (either
source or destination). That is, the switch:
1. Selects an incoming IPv4 packet on the basis of the source or destination
IP address it carries.
2. Overwrites the packet’s DSCP with the DSCP configured in the switch for
such packets, and assigns the 802.1p priority configured in the switch for
the new DSCP. (Refer to “Differentiated Services Codepoint (DSCP)
Mapping” on page 6-58.)
3. Forwards the packet through the appropriate outbound port queue.
Note on
Combining
Policy Types
“Mixing” ToS DSCP policies and 802.1p priorities is not recommended. Refer
to the Note on page 6-10.
For more on DSCP, refer to “Terminology” on page 6-6.
Steps for Creating a Policy Based on IP Address. This procedure
creates a DSCP policy for IPv4 packets carrying the selected IP address
(source or destination).
1. Identify the IP address you want to use as a type for assigning a DSCP
policy.

HP ProCurve Series 2810 Specifications

General

Layer	Layer 2
Form Factor	Rack-mountable
Power Supply	Internal
Jumbo Frame Support	Yes
Uplink Ports	4 x dual-personality ports (10/100/1000 or mini-GBIC)
Switching Capacity	48 Gbps
Throughput	35.7 Mpps
Forwarding Rate	35.7 million pps
Management	Web, SNMP, CLI
MAC Address Table Size	16000 entries
Routing Protocol	Static routing
Features	VLAN support, QoS, IGMP snooping
Operating Temperature	32°F to 113°F (0°C to 45°C)
Operating Humidity	15% to 95% non-condensing
Model	HP ProCurve Series 2810
Ports	24 x 10/100/1000 (Gigabit)