HP ProCurve Series 2810 User Manual

6-28
Quality of Service (QoS): Managing Bandwidth More Effectively
Using QoS Types To Configure QoS for Outbound Traffic
Assigning a Priority Based on IP Address
This option assigns an 802.1p priority to all IPv4 packets having the specified
IP address as either a source or destination. (If both match, the priority for
the IP destination address has precedence.
)
For example, configure and list the 802.1p priority for packets carrying the
following IP addresses:
Syntax: qos device-priority < ip-address > priority < 0 - 7 >
Configures an 802.1p priority for outbound packets
having the specified IP address. This priority
determines the packet’s queue in the outbound port to
which it is sent. If the packet leaves the switch on a
tagged port, it carries the 802.1p priority with it to the
next downstream device. (Default: Disabled)
no qos device-priority < ip-address >
Removes the specified IP device-priority QoS type and
resets the priority for that VLAN to No-override.
show qos device-priority
Displays a listing of all IP device-priority QoS types
currently in the running-config file.
IP Address 802.1p Priority
10.28.31.1 7
10.28.31.130 5
10.28.31.100 1
10.28.31.101 1

HP ProCurve Series 2810 Specifications

General

Layer	Layer 2
Form Factor	Rack-mountable
Power Supply	Internal
Jumbo Frame Support	Yes
Uplink Ports	4 x dual-personality ports (10/100/1000 or mini-GBIC)
Switching Capacity	48 Gbps
Throughput	35.7 Mpps
Forwarding Rate	35.7 million pps
Management	Web, SNMP, CLI
MAC Address Table Size	16000 entries
Routing Protocol	Static routing
Features	VLAN support, QoS, IGMP snooping
Operating Temperature	32°F to 113°F (0°C to 45°C)
Operating Humidity	15% to 95% non-condensing
Model	HP ProCurve Series 2810
Ports	24 x 10/100/1000 (Gigabit)