HP ProCurve Series 2810 User Manual

5-32
Multiple Instance Spanning-Tree Operation
802.1s Multiple Spanning Tree Protocol (MSTP)
Configuring MST Instance Parameters
Command Page
spanning-tree instance < 1..16 > vlan < vid> [ vid..vid ]
no spanning-tree instance < 1..16 >
page
5-32
spanning-tree instance < 1..16 > priority < 0..15 > page
5-33
spanning-tree priority < 0..15 > page
5-34
Syntax: spanning-tree instance < 1..16 > vlan < vid [ vid..vid ] >
no spanning-tree instance < 1..16 >
Configuring MSTP on the switch automatically configures the
IST instance and places all statically configured VLANs on the
switch into the IST instance. This command creates a new
MST instance (MSTI) and moves the VLANs you specify from
the IST to the MSTI. At least one VLAN must be mapped to a
MSTI when you create it. (A VLAN cannot be mapped to more
than one instance at a time.) You can create up to 16 MSTIs
in a region. Use the no form of the command to remove a VLAN
from an MSTI. (Removing a VLAN from an MSTI returns the
VLAN to the IST instance, where it can either remain or be re-
assigned to another MSTI configured in the region.)
The no form of the command deletes the specified MSTI and
returns all VLAN assignments to the region’s IST instance.

HP ProCurve Series 2810 Specifications

General

Layer	Layer 2
Form Factor	Rack-mountable
Power Supply	Internal
Jumbo Frame Support	Yes
Uplink Ports	4 x dual-personality ports (10/100/1000 or mini-GBIC)
Switching Capacity	48 Gbps
Throughput	35.7 Mpps
Forwarding Rate	35.7 million pps
Management	Web, SNMP, CLI
MAC Address Table Size	16000 entries
Routing Protocol	Static routing
Features	VLAN support, QoS, IGMP snooping
Operating Temperature	32°F to 113°F (0°C to 45°C)
Operating Humidity	15% to 95% non-condensing
Model	HP ProCurve Series 2810
Ports	24 x 10/100/1000 (Gigabit)