HP ProCurve Series 2810 - Example of Changing the Priority Setting on a Policy When One or more Qos Types Are Currently Using the Policy

6-62
Quality of Service (QoS): Managing Bandwidth More Effectively
Using QoS Types To Configure QoS for Outbound Traffic
Example of Changing the Priority Setting on a Policy When
One or More QoS Types Are Currently Using the Policy
Suppose that codepoint 000001 is in use by one or more types. If you try to
change its priority, you see a result similar to the following:
Figure 6-33. Example of Trying To Change the Priority on a Policy In Use by a QoS
Type
In this case, you would use steps similar to the following to change the priority.
1. Identify which types use the codepoint you want to change.