HP ProCurve Series 2810 User Manual

5-44
Multiple Instance Spanning-Tree Operation
802.1s Multiple Spanning Tree Protocol (MSTP)
Displaying Per-Instance MSTP Configurations. These commands dis-
plays the per-instance port configuration and current state, along with
instance identifiers and regional root data.
Figure 5-14. Example of the Configuration Listing for a Specific Instance
Syntax: show spanning-tree config instance < ist | 1..16 >
The upper part of this output shows the instance data for the
specified instance. The lower part of the output lists the
spanning-tree port settings for the specified instance.
Syntax: show spanning-tree < port-list > config instance < ist | 1..16 >
This command shows the same data as the above command,
but lists the spanning-tree port parameter settings for only the
specified port(s) and/or trunk(s). You can list data for a series
of ports and port trunks by specifying the first and last port
or trunk of any consecutive series of ports and trunks. For
example, to display data for port A20-A24 and trk1, use this
command:
show spanning-tree a20-trk1 config instance 1
Instance-Specific Data
Port Settings for the
specified instance.

HP ProCurve Series 2810 Specifications

General

Layer	Layer 2
Form Factor	Rack-mountable
Power Supply	Internal
Jumbo Frame Support	Yes
Uplink Ports	4 x dual-personality ports (10/100/1000 or mini-GBIC)
Switching Capacity	48 Gbps
Throughput	35.7 Mpps
Forwarding Rate	35.7 million pps
Management	Web, SNMP, CLI
MAC Address Table Size	16000 entries
Routing Protocol	Static routing
Features	VLAN support, QoS, IGMP snooping
Operating Temperature	32°F to 113°F (0°C to 45°C)
Operating Humidity	15% to 95% non-condensing
Model	HP ProCurve Series 2810
Ports	24 x 10/100/1000 (Gigabit)