HP ProCurve Series 2810 User Manual

7-28
ProCurve Stack Management
Configuring Stack Management
Using Any Stacked Switch To View the Status for All Switches with
Stacking Enabled. This procedure displays the general status of all switches
in the IP subnet (broadcast domain) that have stacking enabled.
1. Go to the console Main Menu for any switch configured for stacking and
select:
9. Stacking ...
2. Stacking Status (All)
You will then see a Stacking Status screen similar to the following:
Figure 7-18. Example of Stacking Status for All Detected Switches Configured for
Stacking
Viewing Commander Status. This procedure displays the Commander and
stack configuration, plus information identifying each stack member.
To display the status for a Commander, go to the console Main Menu for the
switch and select:
9. Stacking ...
1. Stacking Status (This Switch)
You will then see the Commander’s Stacking Status screen:
For status descriptions, see the table on page 7-48.

HP ProCurve Series 2810 Specifications

General

Layer	Layer 2
Form Factor	Rack-mountable
Power Supply	Internal
Jumbo Frame Support	Yes
Uplink Ports	4 x dual-personality ports (10/100/1000 or mini-GBIC)
Switching Capacity	48 Gbps
Throughput	35.7 Mpps
Forwarding Rate	35.7 million pps
Management	Web, SNMP, CLI
MAC Address Table Size	16000 entries
Routing Protocol	Static routing
Features	VLAN support, QoS, IGMP snooping
Operating Temperature	32°F to 113°F (0°C to 45°C)
Operating Humidity	15% to 95% non-condensing
Model	HP ProCurve Series 2810
Ports	24 x 10/100/1000 (Gigabit)