HP ProCurve Series 2810 User Manual

7-34
ProCurve Stack Management
Configuring Stack Management
Viewing the Status of all Stack-Enabled Switches Discovered in the IP
Subnet. The next example lists all the stack-configured switches discovered
in the IP subnet. Because the switch on which the show stack all command
was executed is a candidate, it is included in the “Others” category.
Syntax: show stack all
Figure 7-24. Result of Using the Show Stack All Command To List Discovered Switches in the IP Subnet
Viewing the Status of the Commander and Current Members of the
Commander’s Stack. The next example lists all switches in the stack of the
selected switch.
Syntax: show stack view
Figure 7-25. Example of the Show Stack View Command To List the Stack Assigned to the Selected
Commander

HP ProCurve Series 2810 Specifications

General

Layer	Layer 2
Form Factor	Rack-mountable
Power Supply	Internal
Jumbo Frame Support	Yes
Uplink Ports	4 x dual-personality ports (10/100/1000 or mini-GBIC)
Switching Capacity	48 Gbps
Throughput	35.7 Mpps
Forwarding Rate	35.7 million pps
Management	Web, SNMP, CLI
MAC Address Table Size	16000 entries
Routing Protocol	Static routing
Features	VLAN support, QoS, IGMP snooping
Operating Temperature	32°F to 113°F (0°C to 45°C)
Operating Humidity	15% to 95% non-condensing
Model	HP ProCurve Series 2810
Ports	24 x 10/100/1000 (Gigabit)