2-20
Static Virtual LANs (VLANs)
Port-Based Virtual LANs (Static VLANs)
VLAN Commands Used in this Section
Displaying the Switch’s VLAN Configuration. The next command lists
the VLANs currently running in the switch, with VID, VLAN name, and VLAN
status. Dynamic VLANs appear only if the switch is running with GVRP
enabled and one or more ports has dynamically joined an advertised VLAN.
(In the default configuration, GVRP is disabled. (See chapter 3, “GVRP”.)
Syntax: show vlan
Figure 2-14. Example of “Show VLAN” Listing (GVRP Enabled)
show vlans below
show vlan <vlan-id> page 2-21
max-vlans page 2-22
primary-vlan <vlan-id> page 2-22
[no] vlan <vlan-id> page 2-23
name <vlan-name> page 2-24
[no] tagged <port-list> page 2-24
[no] untagged <port-list> page 2-24
[no] forbid page 2-24
auto <port-list> page 2-24 (Available if GVRP enabled.)
static-vlan <vlan-id> page 2-23 (Available if GVRP enabled.)
When GVRP is disabled
(the default), Dynamic
VLANs do not exist on
the switch and do not
appear in this listing.
(See chapter 3,
“GVRP”.)
To Next Page
Loading...
Need help?
General