4-10
Multimedia Traffic Control with IP Multicast (IGMP)
CLI: Configuring and Displaying IGMP
The following command displays the VLAN and per-port configuration
resulting from the above commands.
ProCurve> show ip igmp 1 config
Configuring IGMP Traffic Priority. This command allows you to
prioritize IGMP traffic as either “high” or “normal” (the default).
Syntax:
[no] vlan < vid > ip igmp high-priority-forward
Assigns “high” priority to IGMP traffic. The “
no” form
returns a high-priority setting to (the default) “normal”
priority. (The switch services the traffic at its inbound
priority.)
ProCurve(config)# vlan 1 ip igmp high-priority-forward
This example configures high priority for IGMP traffic on
VLAN 1.
ProCurve(vlan-1)# ip igmp high-priority-forward
Same as above command, but in the VLAN 1 context
level.
ProCurve(vlan 1)# no ip igmp high-priority-forward
Returns IGMP traffic to “normal” priority.
ProCurve> show ip igmp config
Show command to display results of above high-priority
commands.
Configuring the Querier Function. In its default configuration, the switch
is capable of operating as an IGMP querier. This command lets you disable or
re-enable this function.
Syntax: [no] vlan <vid> ip igmp querier
Disables or re-enables the ability for the switch to become
querier, if necessary, on the specified VLAN. The default
querier capability is “enabled”.
ProCurve(config)# no vlan 1 ip igmp querier
Disables the querier function on VLAN 1.
ProCurve> show ip igmp config
This is the show command used to display results of the
above querier command.
To Next Page
Loading...
Need help?
General
