Hardware options installation 112
Location Discovery Services ear option
To install the component:
1. Power down the server (on page 26).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
o Extend the server from the rack (on page 26).
o Remove the server from the rack (on page 27).
4. Remove the access panel (on page 27).
5. Remove the fan cage (on page 29).
6. Remove the cable protection panel from the left side of the server.
7. Remove the standard ear.
To Next Page
Loading...
